A new generation flight controller for FPV, based on F303 MCU, using F3 MCU controls OSD over SPI bus in DMS mode
The Omnibus flight controller uses the MPU6000 over SPI for the best possible flight performance.
OSD Configation has been incl. in Betaflight GUI.
sbus, DSM2/DSMX to RX connector, 3.3v power
sbus, PPM power 5.0v
STM32 F303 MCU, Runs Betaflight 3.1.0_OMNIBUS firmware, 72MHZ, 256K FLASH
SPI Sensor MPU6000
Integrated BEC: 4 ESC’s PDB, 5V/500mA
Supports Sbus or serial port RX interface, Spektrum 1024/2048, SBUS, XBUS, SumD and SumH RX Built-in inverters
Support: 3.3v Spektrum Satellite receiver
Support: PPM receiver
Buzzer connector available
Weight: 3.1 Grams
Size: 27x27mm, mount holes 25x25mm
Specially designed and built for brushless quads around 80mm and sub 110mm class.
1x F3 AIO flight controller
4PWM output as PLUG and Pinheaders, 4x PWM output as pinheaders
Micro size: Only 27x27mm, mount holes 25x25mm
Supports Lipo 2-3S
STM32 controls OSD chip over SPI in DMA mode, less CPU using, faster rate
External SPI to control VTX or RX; Firmware: betaflight_3.1.0_OMNIBUS, support BLheli-s Dshot esc’s